Thunderstud® Wedge Anchors for anchoring/fastening to concrete.
Customer Testimonials
"The site was easy to get around on, fast and with all the technical information I needed."
Joseph Weigley - Swiftwater, PA
Concrete Wedge Anchors
Concrete Wedge Anchor Installation Instructions
The installation of concrete wedge anchors can be completed in three simple steps outlined below. These wedge anchors work well when anchoring to machinery, piping, and junction boxes. Each anchor comes complete with the correct number of nuts and washers which make installation quick and easy. After installation, the length identification code is stamped on the head to allow for quick anchor quality control and inspection.
1. Drill hole 1/2" to 1" deeper than anchor embedment. Clean hole of debris.
2. With nut threaded past the end of stud, hammer into position.
3. Tighten finger tight plus an additional 3-5 turns with wrench.